Sonoff MINI-RBS Benutzerhandbuch Seite 9

Power On
When you power on the device for the first time, it automatically enters pairing mode.
The blue LED will flash two short pulses followed by one long pulse in a continuous
cycle.
Note:
If no pairing is completed within 10 minutes, the device will exit pairing mode.
•
To re-enter pairing mode, press and hold the button for about 5 seconds until the
•
LED repeats the two-short, one-long flash pattern, then release.
The motor's maximum continuous one-way run time is 2 minutes. Pause
•
operation before the curtain reaches its fully open or fully closed limit to prevent
motor damage.
Check the Device Status
External Switch Types
Supported switch types:
•
Three-position rocker switch (Edge Mode by default)
o
Momentary (pulse) switch
o
To change the switch type, quickly press the button three times. The blue LED will
•
flash three times to confirm the new setting.
Switch-trigger mode cycles in this order:
•
Edge Mode → Pulse Mode → Following Mode
o
9