Werbung
within 10 seconds, the set- up mode is automatically terminated.
5. The LED turns off if the remote accepts the code. If the LED flashes two times, that means the code
may be wrong, and the remote control remains in set-up mode, enter the correct code from the list
again.
6. Check the function of the buttons on the remote control. If it does not function correctly, try
another 4-digit device code (e.g. 0057...) from the list under the same brand. Repeat steps 3 to 6
until all the basic functions operate correctly.
Note: Exit the set-up mode by pressing the device button, or the set-up mode is automatically
terminated if no button is pressed for 10 seconds.
B. Set up by Automatic Search
If setting up by brand name and codes is not successful, or you can not find your brand name in the
code list, you can use the Automatic Search function to find the correct code for your remote control.
1. Switch on the device that you like to control. If it is a VCR, insert a cassette.
2. Point the remote control at your device. Press the device button (e.g. TV) for three seconds, the
LED turns on, keep pressing the device button for about two seconds until the LED starts flashing,
that means it is in Automatic Search now and you can release the device button.
3. The "Volume+" signal is automatically transmitted from the remote control to the device (code
scan). As soon as the volume of the device (e.g. TV) changes, immediately press the device key to
stop the Automatic Search.
4. If the device you are searching for is a CD player, Tuner, TAPE, or AUX, a power signal is
automatically transmitted from the remote control to the device. As soon as the device turns off,
press the device key to stop the Search. You need to turn on the device by pressing the Power button
before you can check the functions of the other buttons.
5. Check the functions of the other buttons on the remote control. If none of the buttons function (i.e.
the search cannot be stopped at the correct time) or the majority of the buttons do not function
correctly, restart the search (see steps 2 to 4) to find a suitable code. If the majority of the buttons
function correctly, set- up has been successful. Re-press the device button (e.g. TV) to save the code
and to terminate the set-up mode.
C. Set up by Manual Search
If setting up with brand name and codes is unsuccessful, you can also use the "Manual Search" to find
the correct code for operating your device.
1. Switch on the device that you like to control. If it is a VCR, please insert a cassette.
2. Point the remote control at the device. Press and hold the device button (e.g. TV) for 3 seconds. The
LED lights up and the remote is in manual set-up mode, release the device button now.
3. Press the "Volume+" button approx. every 1.5 seconds.
4. As soon as the volume of the device (e.g. TV) changes or the device turns off, check whether the
other buttons on the remote control function correctly .If the majority of the buttons does not
function correctly, press the Volume+ approx. every 1.5 seconds to initiate the reactive code
( manual search is continued, see step 3 to 4). If the majority of the buttons on the remote control
functions correctly, save the code by pressing the device button ( e.g. TV) to terminate the manual
search.
Werbung
