Workplace; Installing The Casters; Getting Started - Steba Le 200 Gebrauchsanweisung

Workplace

Important:
Never place this device on or next to hot surfaces (e.g. hot sto-
ves). Only use it on a even, stable and a heat resisting surface. It is
important that no inflammable items are near to the device. Do
not place the device on the edge of the table so that it cannot be
touched by children or fall down when touched.

Installing the Casters

∙ Tilt the device to insert the four casters.

Getting started

∙ Ensure the water tank is properly inserted.
∙ Plug in the power cord.
∙ You will hear a beep and the display will briefly light up.
On/Off switch
∙ Touch the switch; all buttons
light up. The display shows the symbol for the current
operating status.
Mode
∙ By pressing the button, you can select one of the
following modes:
o Sleep mode
Constant dehumidification at low speed
Humidity and speed cannot be changed
The display backlight is turned off and can be
reactivated by pressing the button
o Automatic mode
Humidity is automatically maintained
between 45–55%
Humidity cannot be changed
Speed can be adjusted
o Constant humidity control
The current humidity level is shown on the
display.
The desired humidity level can be set in 5%
increments within the range of 40–80% using +/-.
After 5 seconds, the display will show the current
humidity level again.
15