DAINESE agv CORSA R Handbuch Seite 10

See 10 _
modify the helmet (for example, drill holes or make cuts in the shell, press the polystyrene, cut the retention
See 11 _
abrasions
- do not sit on the helmet or place it on the ground
N.B. Fluo colours are particularly delicate and sensitive to light: Dainese S.p.A. does not guarantee the
duration of the quality of Fluo colours over time.
CARE AND MAINTENANCE OF VISOR AND PLASTIC PARTS
WARNINGS
The visor must been kept in excellent condition at all times to ensure perfect visibility. The
visor must be replaced immediately when it is scratched, damaged or cannot be cleaned
properly. In particular, visibility may be drastically reduced when a visor has scratches or
abrasions, especially in the rain or in the dark when encountering oncoming vehicles with
To clean the visor properly, remove it from the helmet and clean with a soft cloth and the
special AGV cleaner. Alternatively, use a soft cloth moistened in warm water: of the visor
is very dirty, a mild soap can be added to the water. Rinse the visor under running water
and dry it with a soft dry cloth. Both visor and helmet are much easier to clean, and better
results are obtained, if they are cleaned immediately after use.
Never use gasoline, benzene, glass cleaners or other chemical products and solvents, as they
can impair the quality of the visor
Never dry the visor on sources of heat
Do not use sharp or pointed objects to remove dirt from the visor, as these could scratch it.
Do not apply stickers or adhesive tape to the visor
Follow the same instructions to clean plastic parts of the helmet, such as air vents and visor
mechanism. To remove dirt, dust or insects from parts that cannot be reached with a cloth,
try using compressed air. If there is any risk of soiling the inside of helmet during this oper-
ation remove all the padding, or cover it with newspaper to protect it
18
VISOR MOVEMENT
-
Important. We recommend that you carry out the following operations while resting
REMOVING THE VISOR
FITTING THE VISOR
AVAILABLE VISORS
WARNINGS
No anti-fog device can guarantee that a visor will not mist up. What they can do is delay its
formation. This means that with an anti-fog system, it simply takes longer for mist to form.
Under certain environmental conditions mist can and will form on the visor.
PINLOCK ANTI FOG LENS AND TEAR-OFFS
®
®
WARNINGS
Where air temperature is under 20°C and humidity is in excess of 70%, we always recom-
mend the use of Pinlock inserts. The same recommendation applies when it is raining.
®
19
-
-