Beliani CURACAO RL-6181 Montageanleitung Seite 15

Water overflow
Cleaning
1. Use a soft cloth for cleaning purposes, avoiding the use of strong detergents that contain acetone
or ammonia. It is strictly prohibited to disinfect using formic acid or formaldehyde.
2. If there is a scratch on the surface, utilise 2000-grit wet sandpaper to gently polish it. Afterwards,
proceed to polish it further using toothpaste and a soft cloth.
3. Limescale deposits can be removed using vinegar or lemon juice.
4. If the water circulation is blocked, unscrew the nozzles and pipes and clean them.
5. Frequent cleaning is not necessary for the gold-plated and silver-plated components.
6. Please refrain from striking the bathtub with hard objects. Additionally, please avoid direct contact
between the bathtub and hot items that exceed a temperature of 70 °C (e.g., cigarettes). Do not
clean the bathtub with chemical substances that contain bleach.
7. Drain the water and unplug the power cord after use.
8. Cleaning the water massage system: Fill the bathtub with 40 °C hot water and add 2g of detergent
per litre. Let the massage system run for 5 minutes. Afterwards, stop it and drain the water. Refill
the bathtub with cold water and activate the massage system for 3 minutes. You can now drain the
water again, and your massage jets are cleaned.
Precautions
1. Installation should be carried out by a qualified plumbing installer. Please follow the instructions
provided in the manual.
2. Appropriate hoses should be acquired from local sources and connected by a specialist. Under no
circumstances should any connecting hoses provided by the seller be utilised.
3. All hoses need to be checked and sealed by a specialist before using the product and on a regular
basis. Hoses can get disconnected during transportation or over time.
4. When installing the product, the customer must ensure that the front panel is easily accessible at
all times for maintenance purposes and in the event that parts need replacement.
Overflow drain is defective
Nuts are loose
Connecting parts are not correctly
attached
Replace the overflow drain
Tighten the nuts
Inspect the adhesive of the connecting
parts
15