Jole bold R Bedienungsanleitung Seite 13

For installation with Isosafe system + 3-point-belt
41
1
3
2
1. Make sure that both Isosafe connectors are securely
attached to their ISOFIX anchor points. The colors of the
indicators on both Isosafe connectors should be
completely green. -1
41
2. The booster can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the
booster securely. -2&
41
3. Position shoulder belt through the shoulder belt guide
shown in -4.
41
4. It is very important to ensure that any lap strap is worn
low down, so that the pelvis is firmly engaged. The booster
is shown as .
41
23
4
-3
41
For installation with Isosafe system + 3-point-belt + top tether
42
1
3
2
1. Make sure that both Isosafe connectors are securely
attached to their ISOFIX anchor points. The colors of the
indicators on both connectors should be completely green.
-1
42
2. The booster can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the child
restraint securely. -2&
42
3. Make sure that tether hook are securely attached to the
anchorage fitting. The colors of the indicators on tether
strap adjuster should be completely green.
4. Position shoulder belt through the shoulder belt guide
shown in -5
42
4
5
-3
42
-4
42
24