Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Now re-press the programming button of the new transmitter you wish to pro-
gram for 3 seconds.
▻ The LED on the radio socket flashes briefly twice to confirm.
► The new transmitter has now been programmed.
Deleting transmitters
The programmed master transmitter cannot be deleted. It
can only be overwritten (see Overwriting the master trans-
mitter).
Press the programming button on the master transmitter for 3 seconds.
▻ The LED on the radio socket flashes briefly once to confirm.
Re-press the programming button on the master transmitter for 3 seconds.
▻ The LED on the radio socket flashes briefly once to confirm.
Re-press the programming button on the master transmitter for 10 seconds.
▻ The LED on the radio socket flashes briefly twice to confirm.
► All transmitters (except the master transmitter) have been deleted from
the receiver.
Overwriting the master
Switch off the radio socket power supply for 10 seconds; then switch it back
on.
▻ The radio socket goes into programming mode for 3 minutes.
To ensure that the new master transmitter is programmed in
the desired radio socket only, all other receivers which are
connected to the same power supply must be deactivated
from the programming mode.
To do so, after switching the power back on, execute a drive
or stop command using the transmitter for the given receiv-
ers.
18 - en
Werbung
Kapitel
