Disconnect from mains before starting maintenance operation
The following points have to be considered during the inspection:
•
All screws for installing the devices or parts of the device have to be tightly connected and must
not be corroded.
•
There must not be any deformations on the housing, color lenses, fixations and installation
spots (ceiling, suspension, trussing).
•
Mechanically moved parts must not show any traces of wearing and must not rotate with
unbalances.
•
The electric power supply cables must not show any damage, material fatigue or sediments.
CAUTION!
Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
In order to make the lights in good condition and extend the life time, we suggest a regular cleaning
to the lights.
•
Clean the inside and outside lens each week to avoid the weakness of the lights due to accu-
mulation of dust.
•
Clean the fan each week.
•
A detailed electric check by approved electrical engineer each three month, make sure that the
circuit contacts are in good condition, prevent the poor contact of circuit from overheating.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth.
Never use alcohol solvents.
There are no serviceable parts inside the device. Should you need any spare parts, please order genu-
ine parts from your local dealer.
8
Maintenance
Cleaning