Working With The Saw - ATIKA BS 205 Originalbetriebsanleitung

Saw band runs back-
wards
turn the adjusting
wheel clockwise
Saw band runs for-
wards
turn the adjusting
wheel anti-clockwise
After adjusting refasten the fixation screw nut (A).
Transverse adjustment of saw table
Release fixation screw (15).
The saw table can continuously be inclined against the
saw band up to 45°.
Parallel stopper
The parallel stopper (10) is clamped on the saw table. It
can be assembled on the right or on the left of the saw
band.
Pay attention to the right adjustments of the parallel stop-
per.

Working with the saw

Before starting to work consider the following safety ad-
vices to keep the risk of injuries as small as possible.
Saw band o.k.?
Parallel stopper ready to use?
Pushing stick ready to hand?
Upper and lower case door closed?
The case doors protect against touching the driven
parts in the inside of the saw.
Workplace tidied?
You may not start to operate the machine until you have
read these operating instructions, observed all the instruc-
tions given and installed the machine as described!
Before changing or adjusting the saw (i.e. replacing saw
band, inclining saw table, adjusting saw band coping etc.)
− Switch off device
− Wait for stop of the saw band
− Pull out power plug
Also, note the following important points:
Wear protective clothing:
− ear protection
− safety goggles
− protective mask
When sawing do not wear gloves, large clothes or jewels.
Danger of entering!
Take the correct working position. The saw teeth must
face the operator.
Take a position outside the danger zone of the saw band.
Never put into operation the machine when the doors pro-
tecting the saw band are open.
Put the hands plain with closed fingers on the work piece.
Saw only one work piece simultaneously. Never saw sever-
al work pieces or individual items combined as packs simul-
taneously. There is the risk that individual items can be
caught uncontrolled by the saw band.
Do not saw work pieces where cords, strings, bands, cables
or wires are fixed. Danger of entering!
Press the work piece when sawing on the saw table.
Pay attention to that the work piece does not cant itself.
Do not slow down the saw band by lateral pressure.
Use a work piece support plate so that when sawing
long work pieces these will not fall from the table after cut-
ting them through.
Never remove loose splinters, chips, or similar by hand.
At any case pay attention to all security advices.
29