AKO BA-1060 Bedienungsanweisung Seite 8

E1= lowest output = lowest current consumption
H4 = highest output = highest current consumption
E1
9. After H4 comes the final level, AUTO, where the device is switched to automatic operation. In the AUTO
function the current fence status is continuously measured and the optimal output level is automatically
selected! (Recommended setting)
10. After completion of the adjusting procedure, the display switches back to display of the fence voltage.
11. The LED series to the left of the display makes it possible to see the fence status from a distance.
12. By briefly pressing the control knob [1] the current battery voltage is displayed when in use.
The status of the battery can be seen at a quick glance with the battery symbol [4] on the display:
All black: 100%
o
One black bar, one blinking bar: 75%
o
One black bar: 50%
o
One blinking bar: 25%
o
Empty battery symbol: battery capacity nearly depleted
o
Blinking battery symbol
o
(As the battery voltage decreases, the pulse interval increases in order to conserve output energy.)
13. Switch off the device by pressing and holding (approx. 2 sec) the control knob [1] (confirmed by a tone).
Hint:
When connected to the fence, if the device should blink red even in the highest output level, it should be operated
without the fence system connected. If everything is OK then, the fence system must be inspected.
Foal operation: (BD400 & 600)
With the foal operation activated, the device allows the animal to be freed from the fence system without
being shocked.
The foal operation mode is activated and/or deactivated by pressing the control knob [1] for approx. six seconds.
(A continuous tone sounds while the knob is pressed).
A horse symbol appears on the display
activated.
Function of foal operation:
This equipment carries a 3-year warranty in accordance with our Warranty Terms & Conditions!
Please see the attached Operating Instructions for safety tips, earthing, commissioning,
maintenance of battery and accumulator, warranty terms and conditions and potential sources of
fault!
SERVICE Addresses:
Please contact your specialist dealer
E4
E3
E2
Output levels
: Battery depleted
.
As long as this symbol is shown on the display, foal operation is
H2
H1
No fence voltage
The device only releases 1 pulse per minute
and a continuous alarm sounds.
If the load remains in place for more than an
hour, the device continues to operate normally,
adapted to the change of the fence system
(e.g. plant cover).
If foal operation issues an alarm, the guard
security may not be guaranteed on the basis of
the longer pulse interval (necessary for the
animal to be released from the fence without
being shocked)!
6
H4
H3
Version: 2010.1