Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Stand-Alone Mode; Control Board - EuroLite LED ML-56 COB CW 100W Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für LED ML-56 COB CW 100W:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

OPERATION

After you connected the spot to the mains, the LED ML-56 COB CW/WW 100W 60° starts running. The
display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP, DOWN.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.

Stand-alone mode

In the stand-alone mode, you can do without a controller. Disconnect the EUROLITE LED ML-56 COB
CW/WW 100W 60° from the controller.

Control Board

The Control Board offers several features: you can simply set the starting address or the brightness.
Browse through the main menu by pressing MODE. You can browse through the selection menu and confirm
your choice by pressing ENTER. You can change the selection by pressing UP or DOWN. The functions
provided are described in the following sections.
Setting DMX Mode:
Brightness and strobe speed:
Slave Mode:
Dimmer curves (8 types):
The device has 3 DMX channel modes. Press the MODE
button until the display shows CHANNEL. Press the ENTER
button. You can select the DMX channel mode CH02, CH05
or CH06 via the UP or DOWN button. Confirm your choice
by pressing ENTER.
Press the MODE button until the display shows DIMMER to
select the brightness of the LED and the strobe speed.
Press the ENTER button to select the brightness of cold
white (CW) and warm white (WW) and the strobe speed,
respectively. You can select the desired values via the UP or
DOWN buttons.
CW brightness from 01 to 99, increasing.
WW brightness from 01 to 99, increasing.
Strobe (flash) from 01 to 99, increasing speed.
Please press the ENTER button to confirm.
Press the MODE button to select the SLAVE MODE. The
devices set in this manner can now be controlled by the
master unit (s. chapter Master/Slave-operation).
Press the MODE button until the display shows DIMMER.
Press the ENTER button. You can select the dimmer
CURVE: 01-08 via the UP or DOWN buttons (s.
illustration). Confirm your choice by pressing ENTER.
23/28
00070391.DOC, Version 1.0

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Led ml-56 cob ww 100w

Inhaltsverzeichnis