FCC warning
This device complies with Part 18 and Part 15 Of the FCC Rules. Operation
(1) This device may not cause harmful
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant to part 15 of the
FCC Rules.
These limits are designed to provide reasonable
his equipment
generates,
instructions,
may cause harmful
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following
—Reorient
or relocate the receiving antenna.
—Increase the separation
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications
user's authority
to operate the equipment.
(a) Refer to FCCPart 18.213(c) and KDB 784748 Annex A section A.5:
(b) Max. Electric Field Emissions: 5.66V/m Max. Magnetic Field Emissions:0.65A/m
(c) The maintenance
of the system is the responsibility
(d) TOprevent interference,
Charging Pad:
FCC ID: Z2G-PERlPR0713
interference,
protection
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
interference
to radio communications.
measures:
between the equipment
to this unit not expressly approved by the party responsible for compliance
the product should be as far away from devices operating
Mouse:
FCC ID: Z2G-PERlMlCE719R
is subject to the following
and (2) this device must accept any interference
against harmful interference
However, there is no guarantee
and receiver.
of the manufacturer.
Receiver:
FCC
'D: Z2G-PERlMlCERCVR
two conditions:
received, including
in a residential
installation.
that interference
at the same frequency as possible.
C
T
will
could void the