ATOMSTACK A20PRO Bedienungsanleitung Seite 24

7. Positioning
A. The engraver does not know where to engrave, so before you start engraving, there is an important task that is
positioning. We will complete the positioning operation in three steps.
B. Select the "Move to Center" button, the laser will move to the center of the pattern, and the engraving will be
placed below the laser.
1 2
Step2： light laser
Step1： Move to Center
C. Click "light laser" button, the laser will emit a weak light, the laser emits irradiation point is the center of the
engraving pattern, based on this, adjust the position of the engraved object!