Before You Start - Switchbot Strip Light 3 Benutzerhandbuch

Installation

Before you start:

Connect your Strip Light 3 to a power supply and check if it lights up normally.
•
Open our app, tap the "+" icon in the top right corner of the home page, and
•
select Add Device. Find the relevant device icon and select it. Then follow the
instructions to add your Strip Light 3.
Make sure your device works normally before installing it.
•
Steps:
Clean the installation surface and ensure that it is dry and clean.
•
Peel off the tape liner on the back and stick your Strip Light 3 onto the installation
•
surface.
You may secure your Strip Light 3 using the mounting buckles and screws
•
provided, especially at turns.
Note: Do not excessively bend this product.
Connect the controller to the light as shown:
•
Plug your Strip Light 3 in using the power adaptor.
•
Control your Strip Light 3 using the remote control, controller or the app.
•
5