Audizio Reno Bedienungsanleitung Seite 4

CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must
be returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately.
The arising condensation water might damage your device. Leave the device switched off until it has reached room
temperature.
1. Platter
Place your record here.
2. 45 RPM adaptor
This adaptor allows you to play 45RPM records.
3. Tonearm
The tonearm holds the needle and guides it smoothly across the
record.
4. Auto-stop switch
When set to ON, the platter stops automatically at the end of the
record.
If playback stops too early, set the switch to OFF to disable auto-stop.
5. Speed switch
Use the speed switch to select the correct platter speed:
33 1/3, 45, or 78 RPM, depending on the type of record being played.
6. Tonearm clip
This arm clip secures the tone-arm while at rest or when not in use
7. Phono/BT LED indicator
Indicates the status of the phono or BT mode.
8. Cartridge with needle
When the turntable is not in use, it is recommendable to place
the removable protection cover over the stylus.
9. Multi-function knob
Power knob and Volume control.
10. Stereo speaker
11. Speaker out jack -R channel
The audio output from a playing vinyl record is sent to this line-
level. This must be connected to phono level devises.
12. Speaker out jack -L channel
The audio output from a playing vinyl record is sent to this line-
level coaxial audio output. This must be connected to phono
level devises.
13. DC-input
9V Power socket for connecting the supplied power.
AC Power Operation
1. Insert one end of the supplied power cord into the DC-input located at the rear of the unit.
2. Plug the other end into a wall outlet.
3. When using the cord for the first time, firmly push it into the socket.
4. If the unit does not work on AC power, try again to ensure a positive connection.
Playing a Record
1. Rotate the multi-fe clockwise until you hear a "click" sound. The LED indicator will light up, indicating that the unit is
turned on.
2. Place the record on the turntable. If required, place the adaptor on the record spindle.
3. Select the desired playing speed (33 1/3, 45, or 78 rpm) using the speed switch.
4. Turn on the rotary power switch (this also controls the volume).
5. Release the tone arm lock and gently raise the tone arm by hand.
6. Move the stylus vertically over the first track of the record. The turntable will start turning automatically, and the red
indicator will light up.
7. Slowly lower the stylus onto the record to begin playback.
8. When the record ends, the turntable will:
•
Stop automatically if the auto-stop switch is ON.
•
Keep revolving if the switch is OFF, until the tone arm is returned to the rest.
9. Lift the tone arm and return it to the rest when finished. Replace the protective cap on the stylus and close the tone
arm lock.
4