Cleaning And Maintenance - Ricokids Rk-607 Bedienungsanleitung

PARTS (FIG. I)
A – Handlebar
B – Front fork and front wheel
C – Frame and rear wheel
ASSEMBLY (FIG. II)
Assembly of the front fork and handlebar (Fig. II. 1–4): Place the parts on the front fork. Connect the front
fork to the head tube. Install parts 3/4/5/6/7/8/9. Install the handlebar and then tighten it properly.
Assembly of the saddle (Fig. II. 5–7): Insert the seat post into the frame. Adjust the height of the saddle.
Tighten the seat post bolt enough to hold the saddle in place.
INSTRUCTION FOR USE
To be ridden only with an adult or caregiver present to supervise and ensure safety. Sit on the saddle,
grip the handlebar tightly with both hands and push feet alternately against the ground. After developing
higher speed, raise the legs up to ride freely. In order to turn, move the handlebar in the direction of the
turn and balance your body. Put your feet onto the ground to stop the balance bike.

CLEANING AND MAINTENANCE

• Regularly check the condition of the balance bike.
• Cleaning and maintenance should only be performed by an adult.
• Lubricate the moving parts only if necessary, with a light application of a silicone based lubricant. Wipe
off excess lubricant with a clean cloth.
• Periodically check the balance bike for loose screws and other parts. Replace or repair the parts as
needed. Use only certified spare parts.
• In order to avoid friction which may cause the balance bike to work improperly, ensure that all plastic
parts placed along the metal frame are free of dust, dirt or sand.
• Store the balance bike in a dry place. Prolonged exposure to direct sunlight may cause degradation of
the plastic parts.
• Before each ride, make sure that the product is not damaged and all screws are securely tightened.
• Replace worn or damaged parts, or stop using the product.
• Clean the balance bike with a damp cloth and then wipe it dry. Do not use caustic or abrasive cleaning
agents.
D – Saddle and seat post
1-9 – Headset parts, other seat post parts
10 – Assembly key
5