Sharp RG-F251G Serviceanleitung Seite 4

RG-F251G
RG-F252E
Caution on Disassembly
Follow the below-mentioned
unit and reassembling it, to keep its safety and excellent
performance:
I. Take cassette tape out of the unit.
2. Take off nylon bands or wire holders where they need
by removed when disassembling the unit. After servicing
the unit, be sure to rearrange the leads where they were
before disassembling.
3. Take sufficient care on static electricity
circuits and other circuits
STEP REMOVAL
I.
Bottom Cabinet
I.
2 Front Panel
Mechanism Block I.
3
2. Socket
Front
(B)x2
Figure 4
I. Hook a thread as shown
2. Turn the shaft fully counterclockwise
of the dial pointer to the boss at the Back Plate as shown
in Figure 4—4.
+10mm
182
"O" Point
Figure 4—4
DISASSEMBLY
notes when disassembling
of integrated
when servicing.
FIGURE
PROCEDURE
Screw . (A)x2
Knob . .... .............. . (B)x2
4—2
Screw (C)x3
..... ..... ..... .. (D)x2
(A)xl
Panel
9
43x5 mm
Bottom Cabinet
(A)xl
mm
STRINGING
in Figure 4—3.
and fit the left end
the
+3x5 mm
(C)xl
43x5 mm
OF DIAL CORD
Tuning Control
Shaft (1 16)
I .5 Turns
Mechanism Block
(D)xl
Figure 4—2
6 Turns
Spring, Dial Cord (120)
Back Plate {115)
Figure
(C)xl
42.6x4 mm
(D)xl