13. Additional information
13.1 Troubleshooting
Malfunction
Troubleshooting
I pulled the activation
– the undamped explosion
handle without the cartridge
pressure will damage the
being installed
puncture unit and render it
unsafe and unusable . It must
be checked and replaced .
– Direct all queries to your
respective service center .
Activation handle does
– Put a drop of ABS oil into
not attach
the coupler . Push up coupler,
34
attach and remove handle
several times until the coupler
is functioning properly .
– If this doesn't work the
system has to be sent to your
respective service center .
– Do not try to attach the
handle with force .
– If you are out in the field and
you have no ABS oil with you,
push the coupler up, attach
the handle and then push the
coupler down .
140325_ABS_GBA_2014_Innenteil_RZ.indd 34
Downloaded from
www.Manualslib.com
Malfunction
Troubleshooting
The charged activation
– You must leave the full
handle does not come off
cartridge in place .
– Gently push the coupler
upwards, wiggle the handle
from side to side and carefully
try pulling it down .
– In addition apply a drop of
ABS oil to the handle and
turn it to increase lubrication .
– If this doesn't work the system
has to be sent in for service .
The airbags are difficult
– Were the airbags folded
to remove from the
properly?
compartments and are
– Did the weight of the cartridge
hard to inflate
match the filled weight?
– If you answered both with yes
you have to send the airbag
in for service .
– If you are unsure about either
one of these points, perform a
practice activation .
– If the problem persists send
the ABS-System in for service .
English
manuals search engine
Malfunction
After inflating the
airbags there is a definite
background noise
13.2 Warranty
To extend your warranty of the ABS-System from 2 years to
4 years please complete the warranty card on-line no later than
30 days after your purchase under
www.abs-airbag.com
(under
Service/Warranty
(The ABS-System does not include the backpack) .
ABS AIRBAGS warrants that the product will meet the specifi-
cations stated in the instructions and ABS AIRBAGS agrees to
replace the product free of charge if the product does not con-
form to the specifications . Notice for replacement must be given
within 60 days of the discovery of the defect . In consideration of
the above promises by ABS AIRBAGS, the buyer agrees to and
accepts the following conditions:
• That this warranty is in lieu of all other warranties,
expressed or implied;
25.03.14 12:59
140325_ABS_GBA_2014_Innenteil_RZ.indd 35
Troubleshooting
• That all warranties of merchantability or of fitness for a
particular purpose are hereby excluded and/or waived;
– This noise is due to the
• That the buyer's sole remedy shall be to obtain replacement
release valve equalizing the
of the product free of charge from ABS AIRBAGS; and
pressure .
That this remedy is in lieu of all other remedies or claims for
– After a few minutes the
damages, consequential or otherwise, which the buyer may have
pressure drop should not be
against ABS AIRBAGS .
clearly visible any more .
– If the pressure drop is still
ABS AIRBAGS shall have no liability for any loss or injury caused,
clearly visible, the system
in whole or in part, by its actions, omissions, or negligence, or for
needs to be repaired . Send
contingencies beyond its control;
the ABS-System in for service .
The warranty extends only to you, the original purchaser . It is
not transferable to anyone who subsequently purchases the
ABS AIRBAGS from you .
13.3 Technical data
Volume of airbag:
Card) .
Weight of system:
Release:
Filling procedure:
English
35
2 x 85 liter airbags
Approx . 1200g
Pyrotechnical ignition in the activation
handle
Within approx . 1 second 90 liters
(23,8 US gallon) of a gas-air mix
is forced into the two airbags while
the remaining approx . 80 liters
(21,1 US gallon) will take 1 .5 seconds
(depending on outside temperature
and elevation) .
25.03.14 12:59