Mounting; First-Time Operation - Livarno 1118-R-Uk Handbuch

Avoid locations at risk of flooding after
heavy rainfall�
Only suitable for outdoor use when the
„
plug connected to mains power is protected
from the elements�
Ensure that the product is not led through
„
areas where lawnmowers, strimmers, shears
or similar cutting tools are used�
Do not pull the LED rope light
„
If you have any questions regarding the
„
product or are unsure about anything, seek
the advice of an electronics specialist�
Do not use the rope light when covered or
„
recessed into a surface�
TRIPPING HAZARD! Ensure that
the power cable
rope light
1
a way that nobody can tread on or trip over
them�
Mounting safety
instructions
Ensure that the product is only mounted by
„
competent persons�
The product can be fixed to any normally
„
flammable surface with the mounting
equipment included in the package�
RISK OF ELECTRIC SHOCK!
Decide where the product is to be
mounted prior to mounting�
Before mounting, check that the substrate is
„
suitable for the mounting equipment and
the weight of the product� If you are unsure
about anything, seek the advice of an
electronics specialist�
Do not use sharp and/or pointed objects
„
such as wire, nails or staples to mount the
product�
Do not hang any additional items on the
„
product�
Avoid excessive bending of the LED rope
„
light � This will damage the insulation�
1
The bend radius of the rope light must not
„
exceed 2 cm.
�
1
and the LED
2
are positioned in such
Avoid excessive heating of the product. No
„
more than two sections of rope should cross
one another or run parallel to one another�
z Mounting
Please note: Take the product out of its
packaging and remove all packing material�
Check that all package contents are
„
present�
Check if the product or individual parts are
„
damaged� Should you detect damage, do
not use the product� Please contact the
retailer via the service address indicated�
Unwind the LED rope light
„ „
(see Fig� B)�
7
Fix the LED rope light to the desired surface
„ „
using the cable ties
Alternatively, you can use the mounting
„ „
clips included in the package to fix the
6
product in place (see Fig� A)�
To do this, start by screwing the mounting
„ „
clips into a stable substrate with the
6
screws provided, using a Phillips
4
screwdriver (not included in package)�
Push the LED rope light into the openings of
„ „
the mounting clips
If necessary, you can also fix the LED rope
light to the mounting clips
cable ties �
5
z First-time operation
TRIPPING HAZARD! Ensure that
the power cable
rope light
1
a way that nobody can tread on or trip over
them�
Plug the mains plug into a socket that has
„ „
been correctly installed�
from the reel
1
provided (see Fig� A)�
5
fixed to the substrate.
6
using the
6
and the LED
2
are positioned in such
GB/IE/NI
9