Parking Brake - Timago Exclusive-Tim Light Benutzerhandbuch

Place the wheelchair on the ground. Unfold the wheelchair using the armrests.
Then, press the front and rear edge of the seat so that all the elements fit
together.
Step 2. Backrest and seat
Li� the backrest upwards and lock it with backrest locks which are located below
the hand grips. Fix the upholstery on the wheelchair and fasten the lower part of
the upholstery with the use of velcro under the seat.
Step 3. Footrests
Fix the plas�c grip of the footrest on the outer side of wheelchair frame. Then,
put the assembly element of the footrest into the opening in the front of the
frame turning the footrest inwards un�l it is locked.
Step 4. Armrests
The armrests are adjustable in height with the use of a pin on the outer side of
the armrest.
Step 5. Height adjustment of footrests
Adjust the right and the le� footrest by �ghtening the screw which is placed on
the footrest tube with included key. Proper space should be le� between the
footplates and the ground as footplates set too low may cause difficul�es in
overcoming such obstacles as curbs. Adjust the footplates so that the angle
between trunk and thighs is 90
Step 6. Assembly of protec�ve strap
Put the protec�ve strap on the upper part of the footrest to prevent user's legs
from sliding down the footplates.
FOLDING
The wheelchair can be re-folded in order to be transported and stored more
easily.
• Swing away the footplates and set them in ver�cal posi�on.
• Detach the upholstery from the seat.
• Use the handle to li� the seat upwards un�l the frame of the wheelchair is
folded.
• To fold the backrest, press backrest locks and pull the backrest downwards.

PARKING BRAKE

To lock the wheels, push the parking brake lever forward un�l the wheel is fully
blocked (separately for le� and right wheel). Please, note that the wheel lock only
serves to lock the wheels when the wheelchair is at a complete stop.
0 (op�mum si�ng posi�on).
33