Magnum Heating MAGNUM Mat Installationsanleitung Seite 18

11. Tile cement method
• Pull the end of the connecting cable
through the electrical piping to the
thermostat.
• Apply a first layer of Flexible tile adhesive
0,4 cm to 0,6 cm thick and approx. 55 cm
wide.
• Roll the mat out over the tile cement
with the cable facing downwards.
• Softly push the mat down with a wooden
spatula or gloves and spread the tile
cement that oozes through the mat.
• Smooth it over and allow it to dry.
• Take the resistance readings of the mat
again.
• Then apply a second solid layer of
flexible tile adhesive taking care to avoid
air bubbles and use a plastic tile cement
comb to avoid damaging the mat. (DO
NOT SPOT TILE!).
• Press down the tile with a light sliding
motion.
12. Other possibilities
You can also use the section that you have
left over in the wall or the step to the bath.
You can include it in the plaster layer or apply
it with tile cement. This creates a cuddle wall
or comfortable seat. TIP: By installing more
capacity than it is no longer necessary to
install a separate radiator and the MAGNUM
Mat can serve as the main source of heating.
This allows more space for fixtures or furniture.
The capacity must match the heating
requirements / calculations for the space in
question.
Splice!