Storage And Disposal - Bachmann BlueNet BN0500 Bedienungsanleitung

Operation
Activate display
Press the button (1) to reactivate the display.
Button (1) must be pressed for at least one second.
The display will now light up.
Resetting the energy counter
By pressing button (1) for at least 10 seconds, the
energy counter will be reset to zero.
This process can be carried out at any time during
operation (the connected devices do not have to be
shut off).
The displayed kWh counter reading is stored every
30 minutes and retained even if the power strip is
unplugged.
If necessary, write down the current counter reading
first.
Press the button (1) until the kWh counter reading
(arrow) is at zero.
The kWh counter resumes counting immediately
after you release the button (1).
Near overload alarm
When the load reaches 90% of the rated load for the
power strip the display will start flashing.
The alarm will remain even if the load is back under
90% of the rated load.
To quit the alarm, press the button (1) for 3 seconds.
The alarm has been quit.
BlueNet BN0500
What to do if...
Display no longer Unplug power strip from power
shows all readings. supply and plug back in. Strip
re-starts.
No voltage at a Contact our service department.
socket on the strip.

Storage and Disposal

We recommend that the power strip be disconnec-
ted from the power supply and
stored if it is not to be used for an extended
period.
Protect power strips in storage from mois-
ture and dust; for further informationsee
Technical Data.
Do not throw electrical devices into
household waste. These must be disposed
of in an environmentally responsible man-
ner via your local collection point!
english
Connected equipment
must be switched
off before strip is
unplugged.
bachmann.com
11