SECOMP ROLINE ProSecure II 700 VA Benutzer- Und Installationshandbuch Seite 52

13.
Caution!
The factory default settings do not necessarily have to be changed, although you are free to tailor the UPS to
your specific needs.
Settings
Output Volt.Setting
Input/Frequency
Input/Bypass
Voltage
Free Run Mode
Bypass
Enable/Disable at
Free run mode
He mode Setting
Force Manual
Bypass
Management of
Load groups
Do Battery Test
Silence Function
Number of
External battery
Packs
Site wiring alarm
Select Language
Set Generator Mode Generator
Set RS232
communication
LCD
Explanation
display
O/P V
Select Nominal Voltage
Setting
Select input frequency
I/P F Setting range when UPS goes into
free run mode
I/P Bypass Select Input Voltage range
Set when bypass is available
Select if UPS can run in
Free Run
Free run mode
Set
(unsynchronized)
If Enable is chosen, the
Bypass
UPS can go to bypass when
disable
unsynchronized.
HE Mode Select if UPS runs in high
Set efficiency mode
Manual Permanently force UPS to
bypass bypass. For service only.**
You can put the two load
Outlet
groups on and off form
Setting
front panel
Detect battery is normal or
Battery Test
not.
Enable or disable silence
Silence Set
function
This setting is needed
Bat Cabinet
For UPS to predict
Set
Backup time
You can enable or disable
Sit Fault Set
the site wiring alarm
Language Select load language
Set unit in generator mode.
***
RS232 Set RS232 communication
Control enable or disable
22
Factory
Selection
default
208/220/230/240 V 230V
100/110/115/120/127 V 120V
±2%
±5% ±5%
±7%
±10%
+10/-15% +10/-15%
+15/-20%
ON/OFF ON
Disable/Enable Disable
ON/OFF OFF
ON/OFF OFF
1 ON & 2 ON
Both load
1 OFF & 2 ON
segments
1OFF & 2 OFF
ON
1 ON & 2 OFF
ON/OFF OFF
0 (only internal batteries)
1(one external cabinet)
0
2 (two external cabinets)
Enable /Disable Disable
English, German, French,
English
Spanish, Italian.
ON/OFF OFF
Enable/Disable Enable