Control Panel; Ups Configurations - Secomp Roline Prosecure Ii 700 Va Benutzer- Und Installationshandbuch

Status of the UPS, measurements and alarms are all indicated on the LCD screen.
Figure 6.
Normal
The UPS status is shown in normal display mode. From here you have a choice to go to UPS meters display and the Setting
display by pushing the button.
UPS meters display
Various measurements are available through the UPS meters display; pressing the button will scroll through the
following meters:
LCD message
O/P VOLT= xxx, xV
O/P FREQ= xx, x Hz
I/P VOL T= xxx, xV
I/P FREQ= xx, x Hz
BAT VOLT= xx,xV
O/P LOAD%= xx%
O/P W= xW
O/P VA= xVA
O/P CURR= xA
BACKUP TIME= xx min Shows Estimated Backup time in minutes
BAT CHARG= xx%
TEMPERATURE= xxC
BAT PACK NUM= x
RATING = xxxxVA
CPU VERSION xx.x

UPS configurations

7. Various settings that have been chosen are shown in the UPS setting display.
8. To enter configuration mode, press the
will be shown on the LCD display.
9. Press the button to scroll through the parameters.
10. Press the
11. Press the
the button to select the option.
You may be prompted to save the selection, if so press the
selection. Other options are saved and started automatically. See the table below for further details.
12. If no buttons are pressed (or user inactivity) for ten seconds, the UPS shall exit the configuration
mode and return to normal mode displaying Line mode.
Description
Shows Output AC voltage
Shows Output Frequency
Shows Input AC voltage
Shows Input Frequency
Shows Battery Voltage
Shows Load % of max load
Shows Output Watts
Shows Output VA
Shows Output Current
Shows approximate percentage of Battery capacity
Shows approximate ambient temperature
Shows External Battery Pack Number
Shows UPS Rating
Shows CPU Version
button to select the parameter.
button to scroll through the options for the selected parameter; Press
display
button for one second. The first configuration parameter
21

Control panel

button to either confirm or save your