Additional Information - Swedstyle Motion S Betriebsanleitung

10 Swedstyle Motion S - EN
5.3 Container stop
A function used to set a lowest or highest position to table. Used to protect e.g. a drawer
underneath the table top.
Set a highest position:
1. Move the table to the desired highest height that you want to save.
2. Press + simultaneously, within 2-3 seconds release
3. Press slowly 3 times, you will hear a beep.
4. A highest position has now been saved.
Set a lowest position:
1. Move the table to the desired lowest height that you want to save.
2. Press + simultaneously, within 2-3 seconds release
3. Press slowly 3 times, you will hear a beep.
4. A lowest position has now been saved.
Deactivate the container stop:
1. Move the table to the end position that you want to deactivate.
2. Repeat the same steps 2-4 as when activating the container stop. (see above)
5.4 Factory reset
A function if you want to reset all settings as a new box with factory set.
1. Press + simultaneously for at least 30 sec.
(After 5 seconds a beep will sound and the table will move to its absolute lowest position).
2. Hold for another 25 seconds until a long beep is heard.
6
6.1 Disassembly
To disassemble your hand control, ensure that it has been disconnected from the power unit.
Then, follow the assembly instructions in reverse order.
6.2 Maintenance
.
The hand control is maintenance-free for their entire service lifetime.
6.3 Cleaning
1.
2.
.
3.
4.
5.
6.4
1.
2.
3.
4.
5.
6.
6.5 Troubleshooting
Usually, malfunctions occur when hand control are pressed while calibrating. If the hand
control fails to function, you will need to restart the system. To do this:
1.
2.
3.
A list of common problems and their solutions can be found in the operating manual
of the installed control box.
6.6 Disposal

ADDITIONAL INFORMATION

Disconnect the height-adjustable desks power supply from the power source.
Wait 30 seconds for residual voltage to dissipate.
Wipe the surface of the hand control with a dry soft cloth or a soft cloth lightly moistened
in water. Never immerse the hand control into any liquid.
Wait for the hand control to dry completely.
Reconnect the power supply.
Replacing a handset
Disconnect the control box from the mains.
Disconnect the hand control from the control box.
Remove the hand control from the table top.
Mount the new hand control onto the table top.
Plug the hand control back into the control box.
Reconnect the control box to the mains.
Unplug the hand control from the control box.
Plug the hand control back to the motor control box.
After a few seconds the hand control is ready for operation.
Dispose of all components separately from household waste. Use designated collection
points or disposal companies authorized for this purpose
Swedstyle Motion S - EN 11