Lamp Replacement; Technical Data - Heitronic Rhodos Installations- Und Betriebs-Anleitung


Check again that the connection is correct.

Switch on the circuit breaker of the house installation again.

. Lamp replacement


Always replace lamps in good time before the end of their service life to avoid damage to persons, the
luminaire or other objects.

Disconnect the product from the power supply and allow it to cool down before replacing the lamp.

After previous operation, allow the lamp to cool down first.

Use only lamps approved for the luminaire. Information on approved lamps can be found on the type plate.

Before using the luminaire, check that the lamp is properly seated in the lampholder.
. Malfunctions
Luminaire does not switch on / Sockets without function

Light switched on at the switch?

Check the connected lines

. Technical data

Article Connection
37404 230 V ~, 50 Hz
501226 230 V ~, 50 Hz
. Care

First disconnect the entire product from the power supply and allow it to cool down before carrying out any
cleaning or maintenance work on the product.

Clean the product regularly - only with a slightly damp, soft and lint-free cloth.
. Disposal

Waste electronic equipment must be taken to public collection points and must not be disposed of as
household waste.
H. Vollmer GmbH ǀ Allmendring 29 ǀ 75203 Königsbach-Stein ǀ www.HEITRONIC.de
Version
Stainless steel E27, max 12 W LED
Black E27, max 12 W LED
Protection
Lamp
Type
IP 44
IP 44
Protection
Class
I
I
4 / 8 01/22