KMS Idle control kit Handbuch Fur Installation Und Inbetriebnahme Seite 5

EN—NL—DE
kms.vankronenburg.nl
EN
The idle-solenoid needs +12 Volt on one pin and a signal from the KMS management
on the other pin. You can change the polarity without influencing the functioning of
the valve.
To connect/wire the idle-control valve to the KMS ECU's, use pin numbers 4 (MD35
only), 6, 22, 23 or 24 (MP25 only, see next page). For more information see also the
wiring examples on our website. See figure below for correct wiring.
__________________________________________________________
Buy SmartDraw!- purchased copies print this
document without a watermark .
KMS idle control kit
Visit www.smartdraw.com or call 1-800-768-3729.
5
Part nr: 01-01-01-008