Entes GEMO Schnellstartanleitung Seite 5

Digital Input LED
ON: Digital input ON
OFF: Digital input OFF
Digital Output LED
ON: Digital output ON
OFF: Digital output OFF
Setting Interface
In order to configure the device settings from the web interface, it must be connected to the
computer with a micro USB cable. Then you could access the interface via http://usb.entes or
192.168.7.1. The device's password is the last 4 digits of the MAC ID. You could check the device's
connection status to GSM on this interface.
Attention
• Make sure your SIM Card's PIN Code is deactivated.
• Assemble the antenna in the device's box to antenna port on front side.
• Modbus adresses of all devices connected to the modem must be different from each other and
the serial port settings must be same. (Baudrate, parity, data bit, stop bit)
• Make sure that the terminals of the serial communication line (A-B-GND) between the devices to
be read and your device are correct.
• Energized GEMO-02 models do not allow to read any address other than the first two different
addresses.
• Make sure the IP settings of the device are suitable for your network structure (subnet mask,
gateway address, DNS, IP address).
• If there is any firewall at your network, make sure the communication port (502 or 700) is available.
IT Instruction:
Share this information with your IT authorized or technical personnel responsible for internet
access.
If you wish to access any ENTES service via static IP address by your internet provider (TCP server,
static IP communication);
Give access authorization over default port 502 or the relevant port you configured.