Maintenance And Care - Beast Riser Bar Ir Bedienungsanleitung

MAINTENANCE AND CARE

Always inspect your Beast Components products for integrity before
riding. Damage can lead to component failure, resulting in serious
injury or even death. Defective components should not be riden on
under any circumstances and should be replaced immediately. If
you are unsure, contact us or a specialist dealer.
The following points should always be observed:
• After every crash and impact, the carbon handlebar must be
checked for cracks, nicks and dents. To do this, all of the fittings
must be unscrewed. Even if no obvious defects such as cracks,
deformation or the like are visible, we can not guarantee safe
operation. Please consult a specialist dealer or contact us. In
case of doubt, the handlebar should be replaced.
• Attention: It is mandatory to check the Riser Bar for possible
damage after each race, in sports and bike parks because of
heavier loads.
• Regularly check whether the screws are tightened to the
correct torque (see item „Installation").
• Inspect the handlebar for signs of material fatigue and
stresses, such as cracks and dents.
Page 4
INSTRUCTION MANUAL
• Clean your handlebars only with water or, if necessary, with a
commercial detergent.
• Attention: Upon longer exposure, brake fluid may attack
epoxies and resins as well as other coatings used in carbon
components (Brake fluid is highly deliquescent). Therefore,
if brought into contact with any carbon component such as
handle bars please ensure that the affected area is thoroughly
cleaned with water to avoid any damage.
DISPOSAL AND ENVIRONMENTAL PROTECTION
The statutory regulations shall apply. Whenever possible, avoid
creating waste.
Waste, especially carbon, lubricants, cleaners and any other fluids
must be disposed in an environmentally compatible manner.
CONTACT
Black East GmbH
Beast Components
Hermann-Mende-Str. 5-7
01099 Dresden, Germany
+49 351 501 937 00
info@beast-components.de
www.beast-components.de
RISER BAR IR
V2023.01