Technical Data; Noise Emission Specifications; Vibration Specifications; Scope Of Supply - Mafell ZH 245 Ec Originalbetriebsanleitung

2.3 Technical data

Universal motor, radio and TV
interference suppressed
Power input (permanent operation)
Speed of planing shaft
Planing width
Chip removal
Cutting speed at normal load
Weight without mains cable
Extractor connection diameter

2.4 Noise emission specifications

Noise emission values determined according to EN 60745-1 and EN 60745-2-14:
Idling
The noise measurement is recorded using the planing shaft included in the standard equipment.
The values stated do not take into consideration any possible series variances and are not suitable for
determining the rating levels, as these fluctuate in dependence on the time in service, the respective type of
machining and the environmental influences. The noise rating level can therefore only be determined on an
individual basis at the machine user's position.

2.5 Vibration specifications

The typical hand-arm vibration is 2.7 m/s

2.6 Scope of supply

Carpenter's plane ZH 245 Ec complete with:
1 set reversible blades
1 operating tool
1 operating manual
1 folder "Safety Instructions"
while idling
at normal load
Inside / outside
Sound power level
110 dB (A)
2 .
230 V~, 50 Hz
2500 W
8500 rpm
8500 rpm
245 mm (9 5/8 in.)
0 - 4 mm (0- 3/16 in.)
32.9 m/s (108 ft/sec.)
13,2 kg (29.1 lbs)
75/80 mm (2 15/16 – 3 1/8 in.)
Workplace-related emission value
99 dB (A)
-15-