Textron RANSOMES LMAB643 Anweisungen Seite 6

• Disconnect the left hand marker lamp and reconnect to the kit harness as shown on faceing page.
• Run the battery wires along the main battery cables . If fitted, make sure the positive (RED end)
cable is fed inside the rubber terminal boot. Connect the kit harness to the battery.
• Connect the Working lamp electrical cable to the kit harness.
• Test the lamp by turning on the ignition and pressing the light switch. If the light does not come on
turn off the ignition and check that the connections have been made cleanly and correctly.
• Replace the side cover and the bonnet. Make sure that none of the wires are trapped in the hinge.
• When assembled adjust the angle of the working lamp to shine on the working area.
GB-4
CAUTION
Care must be taken around the battery to
ensure that it is not short circuited