Textron RANSOMES LMAB643 Anweisungen Seite 4

MOUNTING WORKING LAMP
• Open the bonnet and disconnect the flashing beacon wire and unbolt the support strut.
• Close the bonnet, remove the split pin from the hinge pin and pull the hinge pin out.
• With the help of an assistant lift the bonnet clear of the machine and place in a suitable work area
• Carefully measure and mark the hole in the position detailed below.
Hole to be drilled Ø12mm
• Bolt the lamp in place so that it will shine downwards onto the brushes.
GB-2
CAUTION
Eye protection should always be worn when
using power tools.
Ø12mm