After Driving; Binding The Transmitter And Receiver; Receiver And Esc Wiring Diagram - Horizon Hobby Axial Summit Racing Jeep Gladiator Bedienungsanleitung

EN

AFTER DRIVING

When you are finished driving your vehicle:
1. Power off the vehicle.

BINDING THE TRANSMITTER AND RECEIVER

Binding is the process of programming the receiver to recognize a specific transmitter signal, thus preventing
interference from other transmitters. The transmitter and receiver included with your vehicle are bound at the factory. If
you need to rebind, follow the instructions below.
NOTICE: Do not attempt to bind the transmitter and reciever if any other compatible transmitters are in bind mode
within approximately 400 feet (120 meters). Doing so may result in unexpected binding to the wrong transmitter and
loss of control of your vehicle.
Prior to starting the binding procedure, ensure the servos and motor are connected to the proper ports on the receiver
and the transmitter has fresh batteries installed.
1. Insert the bind plug into the receiver.
2. Power on the receiver. The receiver LED will flash rapidly.
3. Power on the transmitter. The transmitter LED will flash.
4. When the LED glows solid, binding is complete.
The receiver LED will glow solid when both the transmitter and receiver are powered on. If the receiver LED flashes
rapidly or is not illuminated, the transmitter and receiver are not bound. Power off both the transmitter and receiver and
repeat the binding procedure.

RECEIVER AND ESC WIRING DIAGRAM

Antenna
LED
Battery Port
Motor Port
2. Power off the transmitter.
Forward/Reverse, no
Brake. Recommended
for crawlers.
Power Switch
10
3. Remove the vehicle battery
and charge if necessary.
Mode (Jumper)
Forward/Brake/
Reverse Not
recommended for
crawlers.
Bind Port
Throttle
(For optional external ESC, not
used with stock motor)
Front Steering