Zipper ZI-RWM99 Betriebsanleitung Seite 27

ADJUSTMENT OF THE DRIVING BELT TENSION
1. Remove the weight holder shelf carefully not to tear away the electrical connections.
2. Slightly loosen the four screws fastening the motor. Then shift the motor until the belt is correctly tensioned.
3. Carefully retighten the 4 motor mounting screws. Check then when the belt is running, there is no side deviation.
Place the accessory shelf back in position.
TO REPLACE THE FUSES
Remove the weight holder shelf to gain access to the power supply PC board and the two fused mounted on if the
failure persists, contact the manufacturer or dealer.
27