Fig.7 Cleaning The Condenser Fins - Igloo Innova T 74 Handbuch

• All maintenance should be carried out after disconnecting the unit from the mains!
• Protect the electric installation against shock or water damage
• Do not use water jets while washing the unit. The unit should be cleaned with a damp cloth.
• After cleaning thoroughly, wipe and allow to dry completely. Only stock up the device after it
has dried completely!
• Do not use any sharp objects to remove dirt!
• During cleaning and maintenance of the unit's interior, be careful not to damage or remove
the silicone components (bumpons) that secure glass elements against moving and provide
a better grip.
• Do not use mechanical means to speed up the defrost process!
• Only clean the door seal with clean water without washing agents and remember to dry it
thoroughly. The seal cannot have contact with greasy substances or oil!
• During maintenance work, check that the door closes properly.
Test: put a piece of paper between the seal and the casing and close the door. The paper
should resist when you try to pull it
• Parts of the unit may corrode if used or maintained incorrectly. Observe the following rules:
• Avoid touching the surface of the device with chlorine and/or sodium containing substances
in various variants that damage the protective layer and components (also applicable to
various grades of stainless steel)
The unit's condenser should be kept clean. Contamination hinders heat exchange, causing, e.g. increased electricity
consumption and may cause damage to the compressor of the aggregate.
2

Fig.7 Cleaning the condenser fins

1 – Condenser windchest
2 – Condenser fins
www.igloo.pl
Notes and Tips
1
User manual INNOVA T
en
21