Maintenance And Cleaning - Diamond Ppgf Bedienungsanleitung

3. USE
The grill plate has a plastic protection that must be taken off before using the machine. It is
advisable to clean the plate with a normal kitchen detergent and then grease the plate with a
mixture of olive oil and vinegar.
The grill can now be turned on, to do so, it is enough to push the knob completely, turn it
counter clockwise and press the lighter that is near the tap. The knob must stay pressed down
during 15 to 20 seconds after the burner lights up.
In the knob there is a picture of a large flame (maximum heat) and a small flame (minimum
heat). The space between the two corresponds to the range of flame regulation.
Models PPGF 600 CRD-T and PPGF 800 CRD-T, have thermostatic taps and a graduated
regulating switch, which goes from position nr. 1 (minimum flame) up to nr. 7 (maximum
flame). The numbers in-between correspond to the adjustment of the plaque temperature.
This tap works as follows: when the user turns the machine on, the burners work at the
maximum until the plaque reaches the temperature selected with the regulating switch. When
the plaque temperature stabilizes, the tap automatically reduces the flame and increases it
again, as soon as the plaques starts to cool down. The tap repeats this sequence as many times
as the plaque temperature changes. This procedure is the same for all the switch positions..
All the taps have a security system. If the flame of a burner goes off, the gas supply is
automatically interrupted.
Turning the knob to the position 0 turns off the grill plate.

4. MAINTENANCE AND CLEANING

To clean the plate is advisable to pour a little cold water on it a few minutes after turning the
grill off. The water will facilitate the removal of scraps stuck to the plate. Afterwards, clean it
with a damp cloth and after it cools down, and only if necessary, a small amount of detergent
can be used.
This must be done each time after the fry-top is used.
The tray, which is located in the front of the device, must be taken out regularly and cleaned,
in order to avoid spilling grease on the knobs. To remove it, push it up a little and then push it
out.
The taps do not need lubrication.
5. NECESSARY STEPS FOR THE ALTERATION OF THE TYPE OF
GAS
TUBULAR BURNER
In order to alter the type of gas, do the following:
- Close the gas alimentation tab and take off the alimentation tube.
- Turn the equipment upside down. In this position, the grill plate is turned downwards, the
inferior part upwards. The inside of the equipment is now visible.
- In the inside, open the nut that connects the gas alimentation tube with the gas injector.
- Unscrew the upper fixation screw of the burner. This will simultaneously unfasten the air
regulation nut. From this moment on, it is possible to substitute the gas injector for the
indicated injector.
- When installing a new gas injector, you must fasten de air regulation nut. It is not
necessary to fasten the upper fixation screw of the burner, because the upper fixation
screw of the burner must be fastened after the testing of the burner and after regulation
the air flow.
6 GB