Diamond PPGF Bedienungsanleitung Seite 7

Product
GAS GRILL PLATE
1. INTRODUCTION
This manual should be carefully read and kept for as long as the grill plate is in use.
All operations such as installation, any kind of adaptations (e.i. changing the type of gas), or
any kind of repair, must be carried out by a qualified technician, who should carry out the
regulations in force.
This device should only be used for the specific end for which it was built. It should never be
subjected to other combustible materials, abrasive detergents, or any other objects that might
damage the plate.
Only adults should operate this device, and thus children should avoid touching the grill.
For hygienic and safety reasons, this device must always be kept clean.
These instructions are only valid for the countries mentioned on the ID plate.
2. INSTALLATION
When unpacking the machine, make sure that it is undamaged.
Remove all the materials used for packing as well as the plastic used to protect the structure
of the machine.
Check the label on one side of the machine and make sure that the gas indicated is the same as
the one that is going to be used. If the machine is indicated for another type of gas, please
remember that only a qualified technician may carry out the change.
Choose the place where the machine is going to be installed, bearing in mind the following
instructions:
- The machine must be placed in a well ventilated location, underneath a suction fan
with suction capacity of at least 1500 m
- The grill stand, as well as everything surrounding it must be made out of non-
combustible materials.
- There should be a distance of at least 150 mm between the grill and walls or any other
machines.
- The stand must be well leveled.
- Make sure that the taps are turned off.
It is now possible to connect the gas hose (metallic tube), according to the regulations in
force, avoiding all kinds of pressure, any tight curves or squeezing the tube too much. The
grill must be connected to a fixed installation through a sphere type tap.
INSTRUCTIONS MANUAL
Model
PPGF 800
3
/h
Versions
PPGF 600
PPGF 600 CRD-T
PPGF 800 CRD-T
5 GB