BSS Audio BSS-Case Rodecaster Video Betriebsanleitung Seite 19

Note: Work carefully and avoid crossing cables wherever possible. The more careful the prepara-
tion, the easier the installation of the Rode-
caster Video. Never pull on the cables with
force as this could damage them.
The Rodecaster Video is supplied with its
operating voltage of 19-20V via USB-C. Only
plug this USB-C cable (red labeling) into the
connection provided for this purpose (at the
red power switch). Plugging it into one of the
other USB-C sockets under voltage can cause
DAMAGE to the Rodecaster Video
Plug in the cables
sockets
(Fig. 12) Cable bundle in delivery condition
(Fig. 13) All cables in connected state
never plug into the other USB
Note: for technical reasons, we prefer to use the Micro SD card in the slot of the Rodecaster
Video. With the manufacturer's "RODE Central" software, the card can be easily recorded in the
device via a PC connected to one of the
USB-C ports. However, if you would like to
install an external reader in the case, you
will find the instructions in the chapter:
"Installation slot for an external Micro SD
card reader" on page 18 of this manual
Note: Work carefully and never force the Rodecaster Video into the recess! If you feel too much
counter-pressure or the cover plate deforms under the pressure of the cables, carefully remove
the Rodecaster Video and sort the cables again until it can be inserted into the recess without
too much counter-pressure. You may have to repeat this process several times until the Rode-
caster is seated without pressure.
(Fig. 14) Properly installed Rodecaster Video
(Fig. 15) Screw C-clamps into the
'Rodecaster Video case
DE
EN
FR
IT
ES