Operational Guidelines & Cautions; Maintenance; Environmental Protection; Warranty - Stenroc Isogun Bedienungsanleitung

OPERATION
1. Set the temperature knob to a middle setting.
2. Place blade against foam edge and press trigger.
3. For best results, practice on scrap foam.
4. Cutting should produce little or no smoke.
5. If smoke appears, reduce temperature or increase speed.
Releasing the trigger 2-3 cm before finishing the cut keeps
the blade cleaner.
Blade Length Tip: Blade should extend no more than 2 cm
beyond the foam thickness to avoid overheating.
OPERATIONAL GUIDELINES & CAUTIONS
1. Review the foam material's MSDS sheet before cutting.
2. Always cut in a well-ventilated area.
3. Never burn off residue on the blade.
4. Only activate when in contact with material.
5. Keep hot blades away from skin and clothing.
6. Let the blade cool before touching or storing.
7. Use appropriate gloves and PPE.
8. Not to be used in damp or wet conditions.

MAINTENANCE

• Daily Inspections
• Check casing, switch, and handle for damage.
• Inspect moving parts for obstruction or wear.
• Tighten loose connections before use.
Tool Maintenance
•
• Unplug before cleaning.
• Clean ventilation slots and body with a dry cloth.
• Use a scraper to clean blades and brass holders.
• Clean saw blades every 8 hours using white spirit.
• Repairs
• Only by authorized service centers.
• Never remove covers or screws yourself.

ENVIRONMENTAL PROTECTION

• Follow local laws for recycling power tools.
• Do not dispose of electric tools in household waste.
EU Only:
In accordance with EU Directive 2012/19/EU,
tools must be recycled responsibly. Contact your
dealer for disposal instructions.
ISOGUN

WARRANTY

This tool is covered by a two-year warranty against
manufacturing defects under normal use conditions.

EU DECLARATION OF CONFORMITY

We hereby declare under our sole responsibility that the
product SR 4741505 complies with the following standards or
normative documents:
• EN 55011:20166/A2:2021
• EN IEC 61000-6-2:2019
• EN IEC 61000-6-4:2019
In accordance with Directives 2014/30/EU
5
English