Inserting/Replacing Batteries - Lupilu Rc-16602 Gebrauchsanweisung

• Do not expose the batteries to extreme
conditions (e.g. radiators or direct sunlight).
Otherwise there is an increased risk of leaks.
• Warning. Used batteries must be disposed of
immediately. Keep new and used batteries out
of the reach of children. Seek medical help
immediately if you suspect that batteries have
been swallowed or ingested.
Danger!
• Handle a damaged or leaking battery with
extreme care and dispose of it properly and
immediately. Wear gloves to handle the
battery.
• If you come into contact with battery acid then
wash the affected area with soap and water.
If battery acid gets in your eye rinse it out with
water and seek medical help immediately!
• Do not short-circuit the terminals.

Inserting/replacing batteries

(Fig. B/Fig. C)
WARNING! Comply with the following
instructions in order to prevent
mechanical and electrical damage.
For inserting and replacing the batteries (5)/(6)
proceed as shown in Fig. B/Fig. C.
Note: You will need a suitable screwdriver (not
contained in delivery).
Note: Pay attention to the plus/minus polarity
of the batteries and their correct installation.
The batteries must be located entirely inside the
battery compartment.
IR remote control (Fig. F)
To control the tram with the IR remote control, the
remote control (3) and the tram (1) must be set
to the same channel.
1. Set the control switch (3c) on the remote
control to either A or B.
2. Set the control switch (1a) on the underside
of the tram to the same setting (A or B) as the
remote control.
Note: the tram is turned off when the control
switch (1a) is set to "OFF".
Activating the IR remote control
To control the tram with the IR remote control, the
infrared receiver on the tram must be activated.
1. Set the remote control and the tram to the
same channel, as described above (Fig. F).
2. Press any of the buttons (1b–1d) on the
tram to activate this. Only then can the tram
receiver the remote control signal.
Note: after approx. 5 minutes of inactivity, the
product automatically goes into sleep mode. To
reactivate it, one of the buttons on the freight
tram must be pressed again.
Activating light and sound using the
IR remote control (Fig. D)
1. Press the light button (3a) to activate the light.
2. Press the sound button (3b) to activate the
sound.
Activating light and sound directly
on the tram (Fig. E)
1. Press the front button (1b) to activate the front
light, the sound and to drive forward.
2. Press the middle button (1c) to stop the sound,
the light and the tram.
3. Press the back button (1d) to activate the
sound and to drive backwards.
Warning! The tram is not intended to drive
backwards on bridges or inclines.
Note: the sound is activated for approx. 7 sec-
onds and the light is activated while driving.
Driving the (Fig. D)
tram
1. Push the lever (3d) forwards or backwards to
drive the tram.
2. Let go of the lever (3d) to stop the tram.
Note: if the tram stops following a collision, ac-
tivate it again with one of the direction buttons.
Note: if the lever (3d) is pushed forwards for
longer than approx. 1.5 seconds, the tram will
automatically continue to drive forwards. To stop
it, pull the lever (3d) back once.
If the lever (3d) is pushed back for longer than
approx. 1.5 seconds, the tram will automatically
continue to drive backwards. To stop it, push the
lever forwards once.
GB/IE 9