Herunterladen Inhalt Inhalt Diese Seite drucken

Possible Cause; Troubleshooting - Texas Andreas Petersen BCU33M Bedienungssanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Troubleshooting

PROBLEM
The engine does not start. 1. No spark.
The engine starts but
does not accelerate.
The engine starts but can
only run on full power and
on half choke
The engine does not run
on full power and smokes
heavily.
The engine starts, runs,
and accelerates but
Cannot run idle.
The line cannot be pulled
forward.
Grass is wrapped around
the gear head or line
head.
The spool head is difficult
to turn.
Oil leaks from the exhaust 1. The trimmer is not used on

POSSIBLE CAUSE

2. No fuel.
3. "Drowned" engine.
4. The starter must be pulled
harder than when the
machine was new.
The carburetor needs
adjustment.
The carburetor must be
adjusted, repaired or cleaned.
1. Check the mix of the fuel.
2. The air filter is dirty
3. The carburetor needs
adjustment.
The carburetor needs
adjustment.
1. The line is melted together. Replace. You may be using the tool too close to
2. Too little line.
3. The line is worn short.
4. The line is entangled.
5. The rotations of the engine
are too slow.
1. Tall grass is cut at base.
2. The trimmer is not used at
full speed.
The threads are dirty,
damaged or full of grass.
full power.
2. Check the mix of the fuel.
3. The air filter is dirty.
4. The carburetor needs
adjustment.
Check the spark plug. Take off the spark plug, place
the spark plug cap on the spark plug and place the
spark plug on the metal cylinder. Pull she starter
and check if there are sparks on the top of the spark
plug. If there are no sparks repeat procedure with a
new spark plug. If still no sparks contact local
dealer.
Press the fuel primer. If the problem persists,
contact your local dealer.
Remove the spark plug and turn the trimmer so that
the spark plug hole faces the ground. Switch the
choke to "RUN" and pull the starter 10-15 times.
Clean the spark plug and fit it again. You may also
replace the spark plug. Pull the starter 3 times with
the choke switched to "RUN". If the engine does not
start, move the choke to "Choke" and normal
starting procedure is used. If the engine still does
not start, repeat the procedure with a new spark
plug.
Contact your local dealer.
Contact your local dealer.
Contact your local dealer.
Use new fuel with the correct mix.
Clean or replace.
Contact your local dealer.
Contact your local dealer.
stones and walls.
Fit more line.
Pull out more line while alternately pressing the line
head down and letting go.
Remove the line from the spool and fit it again.
Pull out more line at full speed.
Cut the grass from the top and downwards.
Use the trimmer at full speed.
Clean the threads and grease or change the spool
head. Remove any grass.
Use full power
Use new fuel and correct two-stroke mix.
Clean or replace.
Contact your local dealer.
24
SOLUTION

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Texas Andreas Petersen BCU33M

Inhaltsverzeichnis