Technical Data - Ags Rsc 2 Bedienungsanleitung

ENGLISH
1 . To do this, briefly press the P button on the operator cover or
the P button on the receiver. The red LED will begin to flash,
signalising that the desired hand transmitter button can be
programmed.
2 . Press and hold the hand transmitter button until the red LED
flashes quickly; then release the hand transmitter button.
3 . Press the hand transmitter button again within 15 seconds, until
the red LED begins flashing very rapidly; then release the hand
transmitter button. Once the rapid flashing stops, the desired
hand transmitter button has been successfully taught in and the
red LED will remain lit.
4 . After teaching in the hand transmitter or extending the radio
system, check the functions.
6 Disposal
Dispose of the packaging sorted by materials.
Electrical and electronic devices must be returned to the
appropriate recycling facilities.
Dispose of the batteries separately. Each consumer is
legally required to leave batteries with a collection point in
their community, their district, or with a trader.
7

Technical data

Hand transmitter RSC 2
Model
Frequency
Transmitting power
Coding
Power supply
Perm. ambient temperature 0 °C to +50 °C
Max. humidity
14
RSC2-433
433 MHz
max. 10 mW (EIRP)
Rolling code
1 × 3 V battery, type: CR2032, lithium
93 % non-condensing
4546026 B4 / 32-2025 / DX