Putting Into Operation; Changing The Battery - Ags Rsc 2 Bedienungsanleitung

ENGLISH
Functional disturbances caused by environmental conditions
These conditions can impair function!
Protect the hand transmitter from the following conditions:
• Direct sunlight (perm. ambient temperature 0 °C to +50 °C)
• Moisture
• Dust
NOTE:
Local conditions may affect the range of the radio system. Each time
the button on the hand transmitter is pressed, the LED a emits a
signal (see Fig.
If the LED flashes when the button is pressed, transmission is still
going on but the battery is so low that it urgently needs replacing.
If the LED fails to respond, check whether the battery is correctly
inserted (see Fig.
3

Putting into operation

See Fig. 1
▶
4

Changing the battery

See Fig. 2
▶
3 V battery, type CR 2025, lithium.
• Open the hand transmitter as shown.
• Remove the spent battery and insert the new one, making sure
to pole correctly.
• Re-close the hand transmitter.
12
ATTENTION
1 ). If the LED lights up, the transmitter is operating.
1 ). Replace the battery if necessary.
.
.
4546026 B4 / 32-2025 / DX