Timago TGR-R RA 882 Benutzerhandbuch Seite 25

3. Assembly
UNFOLDING AND FOLDING THE ROLLATOR
• To unfold the rollator, press the side crossbar, which is placed under the seat,
un�l the hinges are completely unfolded. Fix the handles into the moun�ng
openings and select appropriate height. Tighten the locking knobs
a�erwards. Brake cables should be placed in front. Lean the seat onto the
frame.
• Fix the backrest into the moun�ng openings at the front of the rollator un�l
the pins are locked.
• The basket can be hanged on the frame or fixed under the seat.
• Remove plas�c casing from wheels.
• To fold the rollator for transport, lower the seat and pull upwards the strap
which joins the side crossbar with frame un�l the frame is completely
folded.
NOTE! Be careful while folding or dismantling the rollator due to the risk of
smashing fingers in hinges.
BRAKES
• To stop the rollator, pull the brake handle upwards and hold.
• While stop or using the seat, lock the brake with parking func�on by pushing
down the brake handle.
• To release the brake, pull the brake handle upwards.
HEIGHT ADJUSTMENT OF HANDLES
• To adjust the height of the handles, unscrew the locking knobs which are
located on the outer side of the frame, select appropriate height and �ghten
the locking knobs.
Note! The handles must be set on the same level.
ADJUSTMENT OF BRAKES
• Adjustment of upper brake: unscrew the nut of the cable, pull it up to the
appropriate length and lock it by �ghtening the locking screw.
• Adjustment of lower brake: loosen the moun�ng screw with the use of
open-end wrench, pull the black brake cable to adjust the tension of the
cable, and then, �ghten the moun�ng screw.
4. Technical data
Overall width
25
60 cm