montech MKey PRO Benutzerhandbuch Seite 9

Connection Mode (if "MKey PRO 75" Does Not Appear in Bluetooth Settings)
•
To enter connection mode, press and hold FN+1, FN+2, or FN+3 for three seconds.
The selected key will flash a blue light to indicate it is in connection mode, while the
other keys will remain off.
•
Note: If the connection process exceeds three minutes without pairing, the keyboard
will exit connection mode and revert to its original lighting effect. A flashing blue light
will continue for 40 seconds, then turn off, leaving only the backlight flashing.
Multi-Device Connectivity (Connect to Three Devices Simultaneously via
Bluetooth)
•
The MKey PRO can connect to up to three devices via Bluetooth. Each device will
connect by default to a specific FN key:
Device 1: FN+1 channel
o
Device 2: FN+2 channel
o
Device 3: FN+3 channel
o
•
If the connection notification does not appear automatically for any of the devices,
press and hold FN+1, FN+2, or FN+3 for three seconds to activate the connection
channel.
•
To switch between connected devices, simply use FN+1, FN+2, or FN+3 to select the
desired device.
Wireless 2.4 GHz Connection Guide
Follow these steps to set up and use the keyboard with a 2.4 GHz wireless connection.
•
Switch to Wireless 2.4 GHz Mode
Set the MKey PRO to wireless 2.4 GHz (2.4 G) mode using the dedicated
o
switch located at the rear of the keyboard.
Remove the wireless dongle from its magnetic storage compartment above
o
the right key.
9