SPL Crossover Mk2 Bedienungsanleitung Seite 2

Crossover Mk2 – Manual
Start up
1
Read the security advices on page 9!
Make sure that the selected mains voltage of the Crossover Mk2 is according to
2
the mains voltage of your region.
Make sure that the mains switch on the rear of the Crossover Mk2 is set to Off
3
(Off = O / On = I).
4
The standby switch on the front panel has to be set to
5
Connect the supplied power cord to the Crossover Mk2 and an appropriate
mains socket outlet.
The device has to be connected to a socket outlet with a protective earth conductor!
If the supplied power cord does not match your mains socket outlet, please contact your dealer.
6
Turn off all devices you wish to connect to the Crossover Mk2.
7
Use the INPUT switch to select the input. If the INPUT switch is set to XLR, the
XLR input is selected. If the INPUT switch is set to RCA, the RCA input is selected.
Connect the output of your preamplifier to an input (INPUT) of the
Crossover Mk2 using an appropriate audio cable (XLR, RCA).
Audio cables not included in the scope of delivery.
8
Connect the input of your subwoofer power amplifier(s) to the LOWPASS Output
of the Crossover Mk2.
You can connect a stereo, two mono or one mono power amplifier to the Crossover Mk2. In case of a mono subwoofer
application, switch the LP OUTPUT Switch to Mono. In this setting booth LOWPASS Outputs (L and R) will output a
mono signal. The signal is always present at the RCA and XLR outputs.
Audio cables not included in the scope of delivery.
9
Connect the input of your main power amplifier(s) to the HIGHPASS Output of
the Crossover Mk2.
Audio cables not included in the scope of delivery.
2
(standby).