Power Supply - Meteo Control Blue'log Xm Schnellstartanleitung

3
BLUE'LOG ADD-ON MODULES (MX MODULES)
The blue'Log base device can be expanded to provide additional interfaces using various
add-on modules (MX modules). For installation information, see the operating manual for
blue'Log XM / XC or the instructions for the relevant add-on module at
https://www.meteocontrol.com/en/support-learning/downloads.

POWER SUPPLY

The current consumption of the blue'Log must be restricted by using an energy-limited
circuit. A DC source with limited power may also be used. The power supply of the
blue'Log must meet the following requirements:
Device protection
Voltage: 24 V DC | Current: 3.3 A
You will find details about device protection and further connection options in the blue'Log
XM / XC operating manual.
ASSIGNMENT OF CONNECTIONS
The specific connection parameters of the devices to be installed (for example inverters,
energy meter, sensors) can be found in the Compatibility check – blue'Log XM / XC
(https://www.meteocontrol.com/bluelog-compatibility-check/) and the manufacturer's
instructions for the relevant device.
EN