Pur Line RAFY 195 Anleitung Seite 11

PARTS
control panel
louvres
air flow outlet
water inlet
OPERATION
1. Pull the unit outwards from the carton and place it on the floor.
2. Check if the spare parts are complete the same as the spare part list:
Part
Remote control
Instruction manual
Wheel
Wheel with stopper
3. Take out the wheels to assemble. Note: Two wheels with stopper are for the two front
holes (fig.1).
4. Filling the water tank: Pull out the water tank compartment at the front of the unit,
about 10 cm up to the locking pin, and fill the tank with water slowly, and slowly pour
water inside (fig 2).
Notes:
- Water level must be between the MIN and MAX line.
- After few days operation, dust and dirt may reserve in water tank. It is recommended to
change water and clean water tank frequently.
- Water shortage warning. When water lower than Min. Level, "Beep" will sound, and
indicator light will flash.
5. To empty the tank, remove the drain cap (fig 3) from the rear part of the appliance.
6. Get the plug to power and turn on the unit power switch. A short "Beep" sound can be
heard and the power indicator will be on.
lateral filtration
mesh
pump
filter
water
pump
water tank
Quantity
1
1
2
2
EN
lateral cooling
pad
casters
9
rear filtration
mesh
cooling
pad
water
tank cap
fig.1
wheel wheel with
stopper
fig.2
fig.3