Maintenance / Service - Algam Lighting Phoenix Mini Bedienungsanleitung

MAINTENANCE / SERVICE

• Never attempt to disassemble, repair or modify the unit yourself. Otherwise, the warranty becomes void. Repairs by
unqualed persons may result n damage or malfuncton. Please contact the nearest authorzed servce center.
• Disconnect the unit from the mains before servicing.
• If the cable or exble outer cord of ths xture s damaged, t must be replaced wth a specal cable or cord from the
manufacturer or its service agent only.
• Never immerse the unit in water or any other liquid. Wipe only with a slightly damp cloth.
1m above the
sparks
HEATING READY FAULTW ORK
3m around
the machine
DANGER! SPARKS !
FIRE HAZARD
RISK OF INJURY
• Ths machne must only be used wth specc cold spark powders from the brand ALGAM
LIGHTING. Do not use unauthorized products for this type of machine. Do not use
ammable products.
• Never operate the machine with an empty powder tank—risk of overheating. Regularly
check the powder level inside the machine.
• Make sure that no objects fall into the spark outlet or the powder tank.
• Ensure the powder tank is properly sealed before switching on the device. Fill only to the
maximum powder level that allows proper closing of the tank.
• Never block the spark outlet.
• Never use this machine near surfaces (walls, ceilings, decorations), objects, or liquids that
are ammable. In general, mantan a safety dstance of 3 meters between the operatng
machne and any ammable or powder-senstve object (safety zone).
• The machine projects sparks up to approximately 5 meters in height at maximum setting.
Keep a minimum distance of 1 meter between the sparks and the ceiling.
• Ensure that sparks cannot come into contact with surfaces or objects during operation.
• Sparks must be projected vertically;never attempt to tilt the machine or redirect the sparks.
Do not aim the spark projection toward the audience.
• Sparks generates smoke that may trgger re detecton systems.
• Do not use the machine in poorly ventilated areas or areas with strong drafts that could
deect the spark projecton.
• Stand at least 3 meters away before each ignition and never place your face over the
machine. Do not allow anyone to come closer than 3 meters during operation. If you must
approach the operating machine for technical reasons, wear safety goggles. Sparks and
powder projections can cause eye injuries.
• Always keep the machine and its safety zone in view while in use.
• Durng operaton, powder partcles fall on the oor and nearby objects. Be sure to protect
fragle oors and surfaces wth non-ammable materal.
• Do not operate the machine continuously. The maximum recommanded continuous run
time is 30 seconds to avoid overheating.
• Empty the powder from the machine before transporting it or sending it for repair or
maintenance.
P.13