Charging Batteries - Tnb Inselfiewh Bedienungsanleitung

- If the battery compartment does not close properly, do not use the product and keep it out of
the reach of children.
- If you think that any batteries have been swallowed or placed in any part of the body, consult
a doctor immediately.
- This product contains LED light sources.
- Avoid looking directly at the LEDs from a short distance.
- Do not place the product too close to the eyes, especially children's.
- Use the product in normal lighting conditions and according to its intended function.
- L5Do not disassemble the product or attempt to replace the LEDs.
- When the product is not functioning and there is no signal input, it will enter the standby mode
in less than 20 minutes,
DESCRIPTION
1) LED Lighting
2) USB-C Charging Port for LED Lighting
3) ON/OFF Button for the Lighting
4) Tightening Screw
5) Telescopic Handle
6) Bluetooth Remote Control Indicator Light
7) Bluetooth Remote Control
8) Tripod
CHARGING & BATTERIES
Recharging the LED Lighting
Plug the charging cable into the USB-C port of the LED lighting (2). A red indicator light will turn
on during charging.
Replacing the Battery
• Remove the remote control (7).
• Remove the cover.
• Replace the battery.
Note: Remember to remove the battery's protective plastic before first use.
1
USING THE POLE
• Unfold the mini pole.
• Choose your preferred tilt angle by loosening the tightening screw (4) and then tighten the
screw to lock the chosen tilt angle.
• Adjust the telescopic handle (5) to the desired length.
• Insert your phone into the dedicated pole holder.
• The holder can be rotated 360°.
USING THE TRIPOD
• Unfold the legs located at the handle to switch to tripod mode.
• For more stability, lower the telescopic handle to create a central leg.
2
3
10